Russell Hobbs RHFSGEC90SS Bedienungsanleitung PDF herunterladen (Seite 10)

THE BURNERS REQUIRE NO REGULATION OF THE PRIMARY AIR.

ABNORMAL OPERATION

ANY OF THE FOLLOWING ARE CONSIDERED TO BE ABNORMAL OPERATION

AND MAY REQUIRE SERVICING:

l Yellow tipping of the hob burner flame.

lSooting up of cooking utensils.

lBurners not igniting properly.

lBurners failing to remain alight.

lBurners extinguished by oven door.

lGas valves, which are difficult to turn.

IN CASE THE APPLIANCE FAILS TO OPERATE CORRECTLY, CONTACT

THE AUTHORISED SERVICE PROVIDER IN YOUR AREA.

lput the knob back on and turn it quickly from the maximum position to the minimum position, checking

that the flame does not go out ;

l for burners with safety valve make sure that the regulation obtained is sufficient to maintain heating of

the thermocouple. If it is not, increase the minimum

LPG TO TG:Use a thin blade screwdriver to turn the by-pass screw located above left of the gas

valve,shaft as shown right. Turn gently the by-pass screw clockwise to the end completely then turn it

anti-clockwise turn for the Triple ring, turn for the Fish, turn for the Rapid, turn for the Semi-

Rapid and turn for the Auxiliary .

TG TO LPG: Use a thin blade screwdriver to turn the by-pass screw located above left of the gas valve

shaft as shown right.Turn gently the by-pass screw clockwise to the end.

LPG TO NG:Use a thin blade screwdriver to turn the by-pass screw located above left of the gas

valve,shaft as shown right. Turn gently the by-pass screw clockwise to the end completely then turn it

anti-clockwise 1 turn for the Triple ring,7/8 turn for the Fish,3/4 turn for the Rapid,1/2 turn for the Semi-

Rapid and 3/8 turn for the Auxiliary .

NG TO LPG: Use a thin blade screwdriver to turn the by-pass screw located above left of the gas valve

shaft as shown right.Turn gently the by-pass screw clockwise to the end.

NG TO TG:Use a thin blade screwdriver to turn the by-pass screw located above left of the gas

valve,shaft as shown right. Turn gently the by-pass screw clockwise to the end completely then turn it

anti-clockwise turn for the Triple ring, turn for the Fish, turn for the Rapid, turn for the Semi-

Rapid and turn for the Auxiliary .

TG to NG:Use a thin blade screwdriver to turn the by-pass screw located above left of the gas valve,shaft

as shown right. Turn gently the by-pass screw clockwise to the end completely then turn it anti-

clockwise turn for the Triple ring, turn for the Fish, turn for the Rapid, turn for the Semi-Rapid

and turn for the Auxiliary .

1 1

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Keine Kommentare

Russell Hobbs RHFSGEC90SS Bedienungsanleitung Seite 10